CIP (Corrosive Inhibiting Primer) is a rust inhibiting primer which is suitable for finishing with both single and 2-pack paints and finishes. It contains the anti-corrosive properties of Marine Oil which enables it to stabilise the surface by penetrating deep into the substrate, driving out excess moisture and air to form a solid stable layer.
CIP is easy to use and does not require sand or shot blasting first. It can be used on both new and rusted surfaces. It will not dissolve or break down when even high solvent paints and finishes (urethane, epoxy, chlorinated rubber, synthetic, etc.) are applied to it and the pigmentation provides enhanced protection and perfect film-forming qualities. With Owatrol’s Marine CIP, sand or shot-blasted surfaces do not require immediate priming as a light rust coating will not affect its performance or the nal result.
Ideal uses for Marine CIP rust inhibiting primer
- Outstanding for high performance in severe conditions such as marine or tropical environments
- Resisting corrosive fumes
- Protecting ballast tanks of ships
- Perfect protection where a high resistant paint or two-pack finish is necessary
- Outstanding adherance on clean bright steel
CLICK HERE TO VIEW VIDEOCLICK HERE FOR TECHNICAL DATASHEET
|Coverage:||15m2 per litre|
|Tools:||Brush, Roller, Airless Sprayer|
|Suitable for:||Exterior & Interior use|
|Clean up:||White Spirit|
|Drying Time:||6 hours|
|Re-coating Time:||24-72 hours depending on nish – C.I.P. 24 hours; oil/alkyd paints 24-48 hours; high solvent paints i.e. 2 pack, urethane etc 48-72 hours|
|Suitable Surfaces:||Ferrous and non-ferrous metals|